I am getting close to start up, but i have some trouble with the electrical. First i have dismantled a Defa warm up unit. This has been connected trough several wires. I have some bad or wrong connections that i need to sort out. I post some pic from the wires that goes out from the ignition switch. I seem to have one wire too many ?


I also wonder of anyone know what kind of relays that are sitting behind the steering wheel. I do not have any book that explains. I am just courios to know, se pictures.


The car also have a factory alarm. Anyone know if this unit can be dismantled?

Check

Hello,

Thanks a lot for your help.

You mean this whit canister box???


That belang here

Right under the abs pump.

Hello,
Its been a while since last time. Dont know why but it seems like i am constantly running out of time !!! Well to be honest i been doing some other priorities, but the ZX is far from forgotten. I still have some more work to be done in the front, but I have also started at the rear of the car, its time to get the car dropped a little and i have pulled the axel out and i will be going over the brakelines, calipers and bushings as well. The project is coming on nicely and a bit slow.


[/i
mg]
[img

Good luck whit the rear axel. Most of the time its a hel of a job. I realy
Like your car and your project

Fantastic project , keep up the great work

Mark

Thanks for your nice replies. I know that the rear axle can be a pain in the ass, but i will give it a try. I have a back up plan if it fails. Learning by walking.....

how much you droping it by

I am not sure actually, i have a 40mm lowering in front and was thinking 25-30mm.

Well, finally some progress. I dismantled the axle, not a very pleasent job by the way. The tube on one side was completly shot, i then decided to order a rebuild one, got it from UK. Meanwhile i have had the gas tank out and have undercoated the body, also had to weld a whole as the jack has been used wrong. I work on the car when i have time to do so, to many other projects. I am now welding on my better half Saxo Vts, dident now they rust !!

[img][IMG]http://i1128.photobucket.com/albums/m499/eagle59/SAM_1490.jpg[/img][/img]

[img][/img]

cracking project eagle love the workshop keep up the good work!

That really is great work , keep the updates coming .

Mark