Hi,

I bought this ZX Dakar in February 2011 and since then I have been working on the preparation of XU10J4RS.

The car is parked in the garage over a year and we are reaching the end of preparation this month.

Before it leaves the garage he was like this:



In the workshop:


I'm using pistons taxed wossner, 86.5 bore:





The cylinderhead was also tweaked:

Intake:


Exhaust:


Intake manifold was all polished:



Throttle body:


Kit apollo k&n:


Clutch Kit to +30bhp purchased in larkspeed:


I'll use the 300mm front brakes C4 Grand Picasso:


At the rear brake, here in Brazil we use, the front brackets BX 16v and 266mm discs:


I will use the BBS 16" the 406 Coupe:


I hope you like my project and I'm updating the topic ..

Fantastic project , it will be a beauty when it's completed

Mark

I had the same pistons. Onley the come whit à lot of problems.
The weight of the pistons were not the same. There was a different of 10 gram.

I dont know if you check the weight of them?

Nice looking project matey, will be watching for sure!!

Steve.

My pistons were weighed and everything was ok.